Browsing Posts tagged using

13.6V Equalization Mode is used to provide an equalization charge to Wet Cell batteries or unequalized batteries within a battery system. This video provides you a step-by-step guide on how and when to use the 13.6V Equalization Mode. Learn more at: www.geniuschargers.com

The 206B is a powerful 300W charger which allows you to charge 3S lipos at up to 20A. This video shows how to charge six 3S lipos of different capacities at the full 20A using an iCharger 206B, a P350 power supply, and parallel main and balance lead cables which are available from ProgressiveRC.com.

Here is how i charge my batteries when the sun is not shining. this is a 12hp motor attached to a modified electric motor. it has n50 permanent magnets in it. i bought it on eBay. the DC current is fed directly into the outback charger where the solar dc goes into it, this is [...]

Most RC battery chargers require a source of 12 volts to power them and in this DIY video, I show you how to convert an old PC power-supply to a source of 12V that will do the job perfectly. If you have any questions, just ask them in the comments section below or in the [...]

My car battery slowly gets drained if i dont drive the car within 2 dys or so, if i connect a solar trickle charger can i keep it connected all the time, even when im driving or would i have to connect/disconnect or add a switch so that i can turn it off when the [...]

Okay so my battery is empty on my car. How long should I drive it to charge the battery enough? I’m asking because at the same time my gas is below 1/4 of my tank. So I need to get some gas but I don’t want to like drive to the gas station and then [...]

I woke up and my car battery is dead.. there isn’t anyone close to me that can jump start my car. Is there any other options?

How to Charge your Turnigy Radio once you’ve done the $8 Battery Modification. I’ve had a lot of messages and requests for charging this battery pack. I hope this is of help. I’m getting around 10 hours battery life with this setup The balance plug is available through www.rctimer.com

There are three different settings on the charger itself. Do I want to have it on 10 amps, 2 amps, or engine start?